KNX motion detector Komfort

• Wide range with 180° detection angle
• Brightness sensor and three brightness limits
• Adjustment of sensitivity
• On-site operation enables the lighting to be permanently switched on and off
• Can be used as an individual device, a main unit or an auxiliary unit

• Convenient control via infrared remote control
• Easy switching between configured functions
• Integrated temperature sensor
• Easy switching between day/night or week/weekend configuration
• Walking test function
• Energy-saving optimisation through adaptive delay time

Settings such as the sensitivity of detection, twilight stage or additional delay time can be conveniently changed with the infrared remote control, which is available separately. In addition, it is possible to switch the Gira motion detector Komfort on or off manually.

The new generation of Gira motion detectors enables simple switching between �different configurations, such as �day/night mode or week/weekday mode. Five configurable function blocks are available for the three operating modes: security light, security light with
switch-off brightness and detector. All function blocks
operate independently of each other. Which function block is active can be automatically switched in the KNX system or manually switched, for example with the Gira pushbutton sensor 3.

The Gira KNX motion detector offers the option of continuously analysing user behaviour to optimise the delay time (transmission delay) independently. The longer the period during which people are detected in the room, the
longer the delay time. If a room is only entered briefly now and again, the Gira KNX motion detectors reduce the
delay time. This saves energy and conserves the light source by preventing unnecessary switching on and off.

The short-term presence function is available as an addition to the
adaptive delay time especially for light and climate control in
conference or training rooms. If a Gira KNX motion detector detects motion only briefly, it selects the minimum delay time regardless of the self-taught
adaptive value. As a result, lighting, heating/cooling or ventilation
will not remain switched on unnecessarily if somebody enters
the room temporarily during
a longer conference break, e.g. the cleaning staff or catering service.

The on-site operation using a touch function on the motion detector enables a light to be specifically switched on or off permanently and enables the deactivation of automatic motion detection. The current operating status
is displayed via corresponding LEDs. If the operating mode "permanently ON" is activated using the button for on-site operation on the device on the top floor, all the KNX motion detectors change to the corresponding operating mode and this is indicated by the
status LEDs lighting up. On arrival on the lower floor, the whole system can
now be switched back to automatic mode again via on-site operation of the KNX
motion detector installed here.