Gira wireless pull-cord button

The wireless pull-cord button is used to initiate a call in the bathroom or WC. It can be installed on either the wall or the ceiling and can even be reached from the floor using a 2.50 m long pull cord. If the pull-cord button is activated, a red reassurance light confirms successful call initiation.

More about the Gira wireless emergency set

Wireless installation thanks to battery operation

The wireless pull-cord button can be fully battery powered and can therefore be mounted on walls or ceilings without any wiring.

Easy-to-change battery

If the battery power decreases over time, this is indicated by a flashing LED on the device. Only the cover needs to be removed to replace the battery.

Optional power supply via mains adapter

Power can also be supplied via the wireless call module power supply. The battery then serves as a power buffer for power failures.

Technical data

Operating Temperature

+5°C to 40°C

Storage temperature

-25°C to 70°C

Transmission frequency

868.35 MHz

Range

100 m (free field)

Lithium batteries

1 x 1/2 AA, 3.6 V, 1,200 mAh

Product range

Wireless call module

The wireless call module signals that a person requires assistance via a signal light and an integrated buzzer.

Wireless switch-off button

The wireless switch-off button is used to cancel active calls and is installed in the same room as the wireless pull-cord button.

Power supply for the wireless call module

The power supply provides the necessary 12 V voltage for the wireless call module.

System overview

The Gira wireless emergency set allows you to retrofit sanitary areas for disabled people with ease.

Brochures
Gira nurse call systems and emergency sets

Order/download free of charge