Flush-mounted floor empty housing

Flush-mounted floor empty housing

The housing is used to accommodate flush-mounted devices with support ring mounting from the areas of installation and communication technology (e.g. socket outlets, socket outlets with full cover plate, TAE connection boxes etc.). For complete units the

housings can be mounted side by side by means of connecting clamps at the rear. When installed in floors, any water seeping in must be able to drain out via the knockout in the bottom section.


(in mm)

Upper section with hinged cover Die-cast aluminium

W 112 x H 112 x D 61.5 mm

Upper section with hinged cover Matt stainless steel

W 112 x H 112 x T 63.9 mm

Technical data

Protection type

IP 41

The delivery results subject to countries specific assortments

Socket outlets


Gira uses cookies for websites in the gira.com domain. By using our website, you agree to the use of cookies. Our Data Protection Declaration contains more information about the cookies used by us or third parties and the ways in which you can deactivate cookies.